Fast Shoelace Knot

Step 1:

Tie a Left-over-Right Starting Knot as shown, then hold the laces as pictured. The right (blue) lace is held between the right thumb and forefinger whilst the left (yellow) lace is held around the left thumb and forefinger, using the other fingers of the left hand to hold the lace taut.

Step 2:

This move creates two loops, one with the loose end behind, the other with the loose end in front. Use the middle finger of the right hand to push the loose end of the right lace behind, whilst the left hand simply rotates forwards to swing its loop across to the right.

Step 3:

This next move crosses the two loops over each other. Use the left thumb to push its loose end over to the right, whilst the right middle finger continues to push its loose end all the way between the left thumb and forefinger to end up inside the left loop.

Note that the diagram at left shows somewhat exaggerated crossed loops. They are really more "alongside" each other, which is difficult to illustrate.

Step 4:

This tricky move requires each hand to use the two fingers inside its own loop to grab the loose end of the other hand's loop. Use the left thumb and forefinger to grab the loose right end, then the right thumb and middle finger can grab the loose left end.

Step 5:

This move sees each hand releasing its own loop and pulling the loose end of the opposite loop through its own. Take care not to pull the ends all the way through, as this will form a "knot" instead of a "bow". In fact, this is a quick way to tie a starting knot (though the finger movements must be reversed left to right )

Step 6:

This final step simply completes the knot by pulling the loops tight